Electric Bike
Home of Electric Bike Factory
We have power kits for every bike and Trike
See our units in use
Need Help Installing?
Visit Our Online Store To Make A Purchase
Distributors and Dealers are Walcome
About Us
Contact the office of Electric Bike Factory
Power your bike or Trike
Made in the U.S.A.
GoGreen Product

EZ Installation Instructions
The Electric Bike Factory
has made the kit simple to install
Unpacking
The motor comes fully assembled.
The drive motor & bracket assembly
The battery pack cover bag with battery & electronic board inside the bag.
The trigger assembly, (switch and wiring).
Plastic tie straps
Battery Charger
Tools Required
Standard slip joint pliers
A small adjustable crescent wrench
Scissors or Wire Cutter to trim plastic tie straps
Battery Charging & Safety Procedures
Charge your battery for a minimum of 24 hours the first time. After that, your battery should be recharged overnight. We recommend that when you are not using the bike you leave it on charge. The charger is a smart charger and will shut off when the battery is charged and go on again when the battery charge gets low. Note: our battery is 12-volt. Please make sure charger is set on 12-volt.
Always wear a helmet and observe traffic laws and safe bike riding procedures
Universal Front Wheel Motor Kit
Electronic Connection

 
Home | Bike Power Kits | Showroom | EZ Installation | Online Store | Distributors | About Us | Contact Us | Top of Page
Site Design and Support by: Florida Web Service Inc.
  Electric Bike