Electric Bike Factory

Home of Electric Bike Factory We have power kits for every bike and Trike See our units in use Need Help Installing? Visit Our Online Store To Make A Purchase Distributors and Dealers are Walcome About Us Contact the office of Electric Bike Factory Power your bike or Trike with electricity
Electric Bike Factory Motor Kits: Made in the U.S.A.
Electric Bike Factory Kits are a GoGreen Product

EZ Installation Instructions

The Electric Bike Factory
has made the kit simple to install Electric Bike Motor Kit

Unpacking

The motor comes fully assembled.
The drive motor & bracket assembly
The battery pack cover bag with battery & electronic board inside the bag.
The trigger assembly, (switch and wiring).
Plastic tie straps
Battery Charger

Tools Required

Standard slip joint pliers
A small adjustable crescent wrench
Scissors or Wire Cutter to trim plastic tie straps

Battery Charging & Safety Procedures

Charge your battery for a minimum of 24 hours the first time. After that, your battery should be recharged overnight. We recommend that when you are not using the bike you leave it on charge. The charger is a smart charger and will shut off when the battery is charged and go on again when the battery charge gets low. Note: our battery is 12-volt. Please make sure charger is set on 12-volt.

Always wear a helmet and observe traffic laws and
safe bike riding procedures

Home | Bike Power Kits | Showroom | EZ Installation | Online Store | Distributors | Contact Us | Top of Page
Site Design and Support by: Florida Web Service Inc.